Images

Crystal Beauty Jewelry Set
Reset

Crystal Beauty Jewelry Set

Crafting Time:
  • 1-2 Hours
Skill Level:
  • Beginner
Project Courtesy of: Jo-Ann Fabric & Craft Stores
Print Project Description Download Project PDF Add to Project List

Additional Information

Description

SUPPLIES & TOOLS:

BRACELET:

  • 1 Crystal toggle set
  • One 9" Beading wire
  • 2 Silver balls
  • 2 Crimp beads
  • Five 8 mm Swarovski bicones
  • Fourteen 6mm Swarovski bicones
  • Eighteen 4mm Swarovski bicones
  • Eight 4mm Swarovski rondells
  • Crimp tool
  • Needle-nose pliers
  • Wire cutters

EARRINGS:

  • 2 Earring wires
  • 4 Head pins
  • 2 Eye pins
  • 4 Jump rings
  • Four 4mm Swarovski bicones
  • Four 6mm Swarovski bicones
  • Four 8mm Swarovski bicones
  • Four 4mm Swarovski rondells
  • Round-nose pliers
  • Wire cutters

DIRECTIONS:

BRACELET:

  1. String wire through one silver ball, one crimp bead, and the small hole in the toggle. String the wire back through the crimp bead and silver ball and use the crimp tool to secure the crimp bead. String the bead components in the following order: One 4mm bicone; One 6mm bicone; Three 4 mm bicones; One 6mm bicone; One 4mm bicone; One 6mm bicone; One 4mm rondell; One 8mm bicone; One 4mm rondell; One 6mm bicone; Three 4mm bicones; Two 6mm bicones; One 4mm rondell.
  2. This bracelet is symmetrical; the center is an 8mm Swarovski bicone. Complete the bracelet by working the pattern in reverse.
  3. String wire through one silver ball, one crimp bead and the other half of the toggle. String the wire back through the crimp bead and silver ball. Check for fit then use the crimp tool to secure the crimp bead. Trim excess wire as close as possible to the bracelet. Optional: Make bead units to match the earrings and attach to the toggle with jump rings.

EARRINGS:

  1. Two different charms are on each earring. To make the charms, string beads on eye pins in pattern shown, make a loop on the top of the eye pins, or head pin, with the excess wire using round-nose pliers. Snip excess wire.
  2. Make bead units. Bead unit A: On a head pin, thread one 8mm bicone, one 4mm rondell and one 6mm bicone. Make 4. Bead unit B: On an eye pin thread two 4mm bicones. Make 2.
  3. Attach one bead unit A to the loop of eye pin on bead unit B.
  4. Attach one bead unit A and one combined A&B unit to a jump ring. Attach another jump ring and the ear wire.
  5. Repeat steps 3 and 4 with the remaining units.
Reviews
CUSTOMERS ALSO VIEWED