Images

Graphic t-shirts
Reset

Graphic t-shirts

Crafting Time:
  • Under 1 Hour
Skill Level:
  • Beginner
Project Courtesy of: Plaid
Print Project Description Download Project PDF Add to Project List

Additional Information

Description

SUPPLIES & TOOLS:

  • BOTH PROJECTS:
  • Scissors
  • Iron
  • Ruler
  • FOR HOLLYWOOD T-SHIRT:
  • Top-og-raphy Iron-on Transfer, Hollywood
  • T-Shirt, Bright Pink
  • 2 yds. of 1/8" Satin Ribbon, Black
  • FOR GRAPHIC SKULL T-SHIRT:
  • Top-og-raphy Iron-on Transfer, Graphic Skull
  • T-Shirt, White

DIRECTIONS:

FOR HOLLYWOOD T-SHIRT:

  1. Trim closely around transfer design.
  2. Using photo as your guide for placement, lay transfer design face down on T-shirt.
  3. Remove water from iron. Set iron temperature to the cotton setting. Holding transfer design in place, apply iron for approximately 60-80 seconds. Allow transfer to cool then gently remove backing paper. For best results, iron on a clean, hard surface.
  4. Lay T-shirt flat. Cut shirt along bottom hem; cut at sleeves just inside the seams and at neckband just below seam.
  5. Starting approximately 1" from shoulder seam, use scissors to poke small holes approximately 1" apart along both sides of the seams. Repeat on opposite side.
  6. Cut four 18" lengths of ribbon. Take one ribbon and thread it through one hole closest to the armhole, poking ribbon end from the outside of the shirt to the inside. Similar to a running stitch, thread the ribbon in and out of the holes on one side of the seam. At neckline, cross ribbon under the shoulder seam to the other row of holes and thread it in and out alongside the seam. Pull ends of ribbon to gather fabric then tie in a bow. Repeat on opposite side.
  7. At bottom sides of shirt, poke two 6" vertical lines of parallel holes about 1" apart. Follow step 5 above to finish with ribbon.

FOR GRAPHIC SKULL T-SHIRT:

  1. Trim closely around transfer design.
  2. Using photo as your guide for placement, lay transfer design face down on T-shirt.
  3. Remove water from iron. Set iron temperature to the cotton setting. Holding transfer design in place, apply iron for approximately 60-80 seconds. Allow transfer to cool then gently remove backing paper. For best results, iron on a clean, hard surface.
Reviews
CUSTOMERS ALSO VIEWED