Bridal Embellished Clutch

SUPPLIES & TOOLS:

• 1/3 yd Satin fabric
• 1/3 yd Lace fabric
• 1/3 yd Interfacing
• Snaps
• Ribbon
• Hot glue gun
• Fabric glue
• General sewing supplies

DIRECTIONS:

1/2" seams unless otherwise stated.

1. Cut 11"x 18" rectangles - 2 of satin, 1 of lace, 1 of interfacing.
2. Iron interfacing to one piece of satin according to directions.
3. Baste lace to other piece of satin.
4. With right sides together, stitch interfaced satin to lace basted satin, leaving a 3-4" opening on short end that will be the inside hem.
5. Clip corners, turn right side out and press.
6. Press open edge under 1/2" and pin together.
7. Topstitch along edge to close opening.
8. Fold up bottom edge 5" and pin.
9. Topstitch along edge.
10. On top edge, mark in the middle, approximately 5" from the side and 1" from top edge.
11. Stitch snap where marked, making sure to only stitch through one layer of fabric.
12. Fold top over to create a 5" overlap and pin.
13. Mark where bottom snap should be.
14. Unpin and stitch bottom of snap where marked, making sure to only stitch through one layer of fabric.
15. Using pins to hold ribbon in place, spell out "Bride".
16. Tack with hot glue gun where pins are, then glue the rest of the ribbon down with fabric glue.