SUPPLIES & TOOLS:
- Dotz® Sandwich Adhesive roll
- Diamond Dotz®
- Dotz® Stylus, wax and craft tray
- Container or any item you want to decorate
- Dotz® LitePad
- Scissors
- Dotz®
- Black 8001
- Steel 8448
- Chocolate brown 8402
- Brown 8401
- Bark 8400
- Dark wattle 8320
- Wattle 8319
- Light glacier 8132
- Glacier blue 8133
- Cream AB 5007
DIRECTIONS:
Design Size: 35 x 35 Dotz® (3.9"x 3.9")
- Cut out a piece of Sandwich Adhesive in the size of your design.
- Lay the Chart (design facing up) on your DOTZ® Lite surface and position the Sandwich Adhesive piece (paper side down) over the top of the Chart.
- Peel back the clear surface from the top of the Sandwich Adhesive to reveal the sticky surface. Peel back gradually as you dot.
- Dot onto the sticky surface following the chart pattern, making sure to recover with protective film in between dotting sessions.
- Once all dotting is finished, cut evenly around the edge of the dotted design leaving the width of 1 gem around the outside of the design.
- Peel the backing paper away from one small corner of the underside of your project and secure the small sticky area onto your final surface.
- Once secured in one corner, gently peel the remaining backing paper away, sticking your dotted design down as you go.
JOANN HACKS:
- Start at the top dot on the very right side row and fill the right side vertical row first.
- For best results use Dotz® Sandwich Adhesive on smooth, clean, dry surfaces. Not suitable for use on fabrics or uneven surfaces.
- Once your design is secured on the final surface, place the protective film over the Dotz® and roll over firmly with a rolling pin.