SUPPLIES & TOOLS:
- Chipboard for cutting machine
- Foil Quill, tip of choice
- Foil Quill Foil, color of choice
- Foil Quill thumb drive
- Foil Quill tape
- Cutting machine & supplies
DIRECTIONS:
- Follow the set up instructions for your cutting machine. There are four different adapters that are available.
- Insert Foil Quill into the machine carriage and fasten according to machine instructions.
- Plug in Foil Quill USB to power source, it will light up.
- Allow to heat up 5-10 minutes before use.
- To set up the foil, trim foil to desired design size.
- Adhere Foil Quill tape to the top edge of the foil and place on the surface of the chipboard, repeat on all sides; make sure the foil is flat and secured with minimal wrinkles.
- Place chipboard on machine's cutting mat.
- Follow your machine's operating instructions for drawing pen.
- Find the design you would like to use on the Foil Quill thumb drive.
- Follow your machine's instructions to have the Foil Quill draw your design.
- Once the machine is finished, remove the tape and the foil.
- Select the shape you would like your coasters to be cut out in.
- Once cut, remove from mat.
JOANN Hacks:
- Always unplug Foil Quill when not in use.
- Do not use for more than 3 hours.
- Seal with waterproof Mod Podge.