Gaming Bean Bag Chair and Pillow

SUPPLIES & TOOLS:

GAMING CHAIR:

• Sewing machine
• Sewing Notions
• Iron & Ironing Board
• Rotary Cutter & Cutting Board
• Marking Pen
• Quilter's Rule
• Yardstick
• 2 1/2 Cubic ft Biggie Bean Bag Filler (3-4 pks)
• 56" x 2 2/3yds Fleece Fabric

14" FLANGED PILLOW:

• 5/8yd Fleece Fabric
• Sewing Machine
• Basic Sewing Supplies

DIRECTIONS:

GAMING CHAIR:

1. Fabric layout is for directional fabric. Cut all parts. Use 1/2" SA. Match corners. Topstitch 1/4" from seams.
2. RST seat to seat back. Press seam to seat and topstitch.
3. RST inside arms to seat and seat back, match 17 1/2" sides.
4. Directional pattern top at top corner of seat back. Cut toward seam at corner. Press seams to seat and seat back and topstitch. Repeat.
5. RST front to seat.
6. RST side to inside arm and front. Match 13" edge of side to 13" side of front. Press 13" seam to front and topstitch. Repeat.
7. RST 29" edge of back to top of seat back.
8. RST 23" side of back to 23" side of side. Press seam to side and topstitch. Repeat.
9. Turn RSO. Press top perimeter seams of chair stacked. Back/seat back, side/inside arm x 2, seat/front. Topstitch.
10. Turn inside out. RST base to front, sides and back. Leave 5" opening on back edge. Sew again 1/4" from raw edges. Trim all corners to reduce bulk. Turn RSO.
11. Fill with bean bag filler.
12. Hand stitch opening closed.

14" FLANGED PILLOW:

1. Cut one 18" square for front.
2. Cut two 12" X 18" pcs for back.
3. Finish one 18" edge of each back pc.
4. Place front pc right side up.
5. RSD overlap back pcs (finished edges to center) on top of front.
6. Stitch perimeter.
7. Turn right side out.
8. Stitch 1 1/2" from finished edge.