Halloween Cricut and Resin Tumbler

by JOANN |

Item # 262225213P200

Intermediate Varies

CHEERS & FREARS RESIN TUMBLER
_x000D_ SUPPLIES & TOOLS:_x000D_

_x000D_
_x000D_ DIRECTIONS:_x000D_

To download the SVG files, to load directly into Cricut Design Space click on the links below.
Cheers & Fears SVG Click Here

_x000D_ _x000D_

Mask off the top and bottom edge of the tumbler.
Thin out your acrylic paint just a little bit so that it is thicker than ink.
With your medium paint brush randomly apply thin streaks of the metallic blue and purple paint from the bottom upward.
While the paint is still wet, take the plastic wrap and wrap it around the tumbler in a sloppy manner and quickly pull it off to create the "crinkled effect". You can repeat this process to make more vibrant layers if you desire. Let it dry.
Place the tumbler onto the tumbler turner. Make sure it is balanced before mixing the resin.
Mix the resin according to the package instructions. Put a thin layer of resin onto the tumbler.
Let it spin for 8-12 hours. Remove the tumbler carefully, not to put fingerprints on it.
Size the phrase, "Cheer & Fears" to fit the front of the mug using your Cricut machine and white vinyl on the green mat.
Use your weeder to pick out the phrase and skull.
Use the Transfer tape to apply the phrase and skull to the front of the tumbler.
Place the tumbler back on the tumbler and apply another layer of resin. Let it spin for 8-12 hours. Remove off of the tumbler and trim off any excess resin around the top of the tumbler with your X-Acto Knife.

_x000D_
_x000D_ JOANN HACKS:_x000D_

Use the heat gun to remove any air bubbles. Be careful not to get too close to the resin with the heat gun. Make sure it is level as it is spinning. Check on it a couple of times early in the drying process.

_x000D_
_x000D_ FRESHLY BREWED MUG & POISON TUMBLER
_x000D_ SUPPLIES & TOOLS:_x000D_

_x000D_
_x000D_ DIRECTIONS:_x000D_

To download the SVG files, to load directly into Cricut Design Space click on the links below.
Freshly Brewed SVG Click Here
Poison SVG Click Here
Poison Background SVG Click Here

_x000D_ _x000D_

Open Design Space and upload SVG file image "Freshly Brewed".
Measure your mug and size freshly brewed image to fit.
Change design to black.
Attach design.
Insert "Poison" SVG file image and change to white.
Measure your tumbler thermos and size poison image to fit.
Unlock the image and adjust size easier to fit longer bottles.
Cut with Cricut, make sure to change the material setting from Infusible ink or to vinyl.
Infusible ink should be mirrored while following on screen cutting directions.
Weed materials.
Use heat resistant tape to place freshly brewed image on mug and press.
Place transfer tape over poison image and place on tumbler.

_x000D_
_x000D_ JOANN HACKS:_x000D_

Wipe the mug clean with a cloth to rid of any small particles.
Use a scraper tool on the vinyl to assure very small pieces detach from the excess weeded material.

_x000D_