SUPPLIES & TOOLS:
- We R Memory Keepers Tumbler Turner
- White Tumbler
- Lime Green Vinyl
- Dark Green Vinyl
- Taupe Vinyl
- Brown Vinyl
- Resin and Resin Hardener
- Cricut Machine
- Cricut Weeder
- Plastic Gloves
- Mixing Containers
- Popsicle Sticks
- Paper Towels
- Painter's Tape
- Fine Grit Sandpaper
- X-Acto or Craft Knife
- Optional: Heat Gun
DIRECTIONS:
- In Cricut Design Space, select a cheetah print and monstera leaves.
- Size them to fit your tumbler. Cut out the cheetah prints and monstera leaves with the vinyl.
- Use your weeder to pick out the shapes.
- Apply the leaves and cheetah prints randomly on the white tumbler.
- Place the tumbler onto the tumbler turner and make sure it is level.
- Apply a thin layer of resin onto the tumbler.
- Let it spin for 8-12 hours.
- Sand off any bumps with the fine grit sandpaper.
- Apply another thin layer of resin and let it spin for 8-12 hours.
- Remove it from the tumbler turner and trim off any excess resin around the top of the tumbler with your X-Acto knife.
JOANN HACKS:
- Use a heat gun to remove any air bubbles from the resin. Be careful not to get too close to the resin with the heat gun or it will cook.
- Make sure the tumbler is level as it is spinning.
- Check on it a couple of times early in the drying process.