Office Mask

SUPPLIES & TOOLS:

• 100% cotton fabric for Mask
• 2yds deerskin lace, for ties
• Pattern template (download PDF under print description above)
• Basic sewing supplies
• Cricut iron-on vinyl
• Cricut machine & tools

DIRECTIONS:

1. Download the pattern by clicking “download PDF” below Print Description on the right.
2. Cut out patterns using cutting directions on the pattern
3. Seam allowance is 1/4" unless stated otherwise.
4. For the ties, cut deerskin lace into four 18" pieces - set aside.
5. Match outer mask pieces right sides together and sew the outer curve. Repeat with lining pieces.
6. Open both mask halves and press both seam allowances to the right.
7. Topstitch down the seam allowance, about 1/4" from the seam.
8. Lay one half of the mask down with the right side facing up. Pin raw ends of ties in each corner, placing them 1/2" up/down from the top and bottom edges. Finished tie ends should extend toward the middle of the mask. Once ties are pinned in place, bundle the tie ends together in the center of the mask.
9. Match front and back pieces right sides together, nesting center front seams.
10. Pin and sew around the exterior of the mask, leaving a small opening at the bottom of the mask between the center front seam and corner.
11. Clip across corners, taking care not to cut through the stitching.
12. Turn mask right side out and press.
13. Topstitch around the mask, closing the hole at the bottom in the process.
14. Once mask is complete, cut word or design of choice from iron-on vinyl and apply to the mask following the directions included on the package.

 

Please read and follow all manufacturers' instructions for all tools and materials used. Provide adult supervision if children participate in this project. Masks are not intended for hospital or medical use and are not OSHA certified. Please follow CDC guidelines for use of masks.