Reflective Trim Mask

SUPPLIES & TOOLS:

• 1 - Fat Quarter Fabric (18" x 20") for mask
• 12" - 2" wide reflective tape
• 1 - Fat Quarter for bias ties
• ¼ yd - Lightweight fusible interfacing
• Basic sewing supplies

DIRECTIONS:

1. To print the patterns, click on the "Download Project PDF" button (above).
2. Cut 4 - main pattern for mask adding 1/4" both sides for casing. (2 for lining and 2 for outside)
3. Cut 4 - interfacing
4. Fuse interfacing to main 4 pieces of mask.
5. Match two pieces of fabric mask right sides together, and sew the outer curve using 3/8" seam allowance
6. Repeat with remaining two pieces.
7. Open pieces and press both seam allowances to the right.
8. Top stitch down the seam allowance, about 1/4" from the seam.
9. Cut 2 reflective tape pieces for each side of mask front.
10. Pin to front of mask 1" from sides and stitch in place.
11. Match front and back pieces right sides together, nesting center front seams.
12. Pin and sew around the exterior of the mask, leaving a small opening at the bottom of the mask for turning.
13. Turn mask out and press.
14. Top stitch edge of mask, closing the hole at the bottom in the process.
15. Fold both sides to back 1/4" and sew at edge forming a casing.
16. For ties - cut 4 to 5 - bias strips 1 1/4" wide.
17. Stitch strips together at short ends.
18. Fold biass trips in half lengthwise and press.
19. Fold edges into center and press again.
20. Top stitch along open edge..
21. Cut strip in half and insert each piece through casing.