SUPPLIES & TOOLS:
- Jean jacket in desired size
- 7 1/4" wide lace with two finished edges*
- 1 1/4" wide lace with two finished edges*
- 12 assorted white sew-through buttons
- Coats dual-duty XP all-purpose thread, to match lace
- Coats denim thread
- Zipper foot (optional)
- Basic sewing supplies
- Sewing Machine
*To figure yardage: For the wide lace, measure the jacket band lower edge and quadruple this measurement. For the narrow lace, measure the jacket lower band edge, plus both cuffs and add 4".
- From the wide lace, cut 1 piece twice the length of the jacket band measurement.
- Trim 2" off the upper edge evenly along the entire piece.
MAKING THE LOWER RUFFLE:
- Right sides up, stack the trimmed lace over the untrimmed lace, matching the upper edges.
- Sew a line of gathering stitches 1/4" from the upper edges through both layers.
- Mark the center back on the jacket and the center of the stacked laces. Matching the center points, lap the jacket lower edge over the gathering line. Distribute the gathers evenly around the band and extend each lace end 1/4".
- Using denim thread, edgestitch the lace to the jacket band's lower edge.
- Using matching thread, fold the ends of the lace under and topstitch together. Repeat for the opposite side of the jacket.
- Using the narrow lace and matching thread, stitch both sides along the band lower edge, turning under the ends to finish.
- Carefully work the lace around any buttonhole and grommets so that they are still functional. A zipper foot may be helpful to stitch around grommets.
TRIMMING THE CUFFS:
- Using the trimmed lace from the wide ruffle upper layer, cut two pieces twice the length of the cuff measurement.
- Stitch a gathering line 1/4" (.64cm) from the cut edge.
- Following the method outlined above, stitch the lace to the cuff lower edge.
- Sew the narrow lace to the center of the cuff, turning under both ends to finish. End the underlap side just before the grommet.
- Sew around the existing buttonhole and cut the opening through the lace. Repeat for the second cuff.
TRIMMING THE COLLAR:
- Position 6 buttons on each collar point and hand-stitch in place using varying patterns for attaching the buttons to add interest.