SUPPLIES & TOOLS:
DIRECTIONS:
JOANN HACKS:
- Red Hydration Tumbler
- We Tumbler Machine
- I Heart Resin, 1 Large Container of Each (hardener and resin)
- Cricut Machine
- White Adhesive Vinyl
- Green Cutting Mat
- Cricut Weeder
- Painter's Tape
- Plastic Gloves
- Mixing Containers
- Popsicle Sticks
- Paper Towels
- Fine Grit Sandpaper
- Heat Gun
- X-Acto Knife
- Cricut Machine
DIRECTIONS:
- Cut out the heart in Design space and with your Cricut machine. Apply the heart to the sides of the tumbler. Place the tumbler onto the machine and apply a medium layer of resin following resin packaging instructions.
- Remove off of the tumbler and trim off any excess resin around the top of the tumbler with your x-acto knife.
JOANN HACKS:
- Use the heat gun to remove any air bubbles.
- Be careful not to get too close to the resin with the heat gun. Make sure it is level as it is spinning. Check on it a couple of times early in the drying process.