SUPPLIES & TOOLS:
- Thread
- John Bead Czech Seed Beads Size 11/0, Opaque Metallic Gold
- 4mm Glass Pearl Beads
- Jump Rings
- 12mm Silver Lobster Claw Clasp
- Chain Nose Pliers
- Scissors
- Beading Mat
DIRECTIONS:
To find the downloadable patterns click on the "GET PATTERNS" tab above.NOTE: The bracelet may have a natural curve to it. This look is part of the style.
- Cut 75 inches of thread. Thread a size #10beading needle onto each end. String an S11 bead onto one of the needles and bring the bead approximately 25 inches down the thread. *Pick up a Pearl bead with each needle. String an S11bead onto one of the needles and bring it down next to the Pearl. Bring the other needle through the S11 bead, in the opposite direction. Repeat from * to desired length.
- When you have reached the desired length for your bracelet, exiting from the last S11 bead added, string (3)S11 beads, a clasp, and (3) S11 beads onto one of the strands. Go back through the S11 your thread was exiting at the beginning of this step. Go through all the beads again to reinforce.
- With the other needle, go through all the beads once more to reinforce.
- Weave in the shorter of the strands and tie off. With the longer strand, weave through the bracelet to reinforce until you reach the first S11 on the other end. Pick up (3)S11 beads, a jump ring, and (3) S11 beads. Go back through the S11 your thread exited.
- Reinforce this loop three times. Weave in remaining thread and trim.
- Tip: To weave in thread, follow the thread path through the beads, changing direction several times.
JOANN HACKS:
- Attach additional jump rings to the end to form an adjustable chain.
- Add charms if desired.
- Finish with any chain or clasp of your choice.