SUPPLIES & TOOLS:
- 25-27 spools Dual Duty XP thread in a variety of colors
- Circular mirror, 13" diameter
- 2/3 yd grosgrain ribbon, 1 1/2" wide
- Hot glue gun and hot glue
DIRECTIONS:
- Cover the work surface with paper to protect from glue.
- Trim thread ends that may extend from the spools.
- Lay the mirror right side up on the protected work surface.
- Using a pencil, make 4 evenly-spaced marks around the edge of the mirror.
- Lay out the thread spools on the mirror. NOTE: Adjust the spools for the best fit.
- Position the spools so that all the labels are pointing the same direction: inward or outward.
- Working with one spool at a time, carefully lift it and draw a bead of glue down one side of the spool and reposition it on the mirror.
- Glue the spools located at the quarter-marks first, then glue spools within each quadrant, spacing equally between spools. Allow glue to dry thoroughly.
- Turn the mirror over and glue the ribbon hanger in place, making ends at a slight angle for better hanging.